TYCORUN 12V 100Ah LiFePO4 Smart Lithium Iron Battery W/ Built-in Bluetooth IP65. TYCORUN 12V 100Ah Deep Cycle BMS Battery.
100Ah (10 Hour Rate to 10.5V). M8 x 1.25 x 20 mm. 13.6V13.8V; Temperature Compensation: -18mV/? 14.4V14.8V; Temperature Compensation: -24mV/?
In Series, and In Parallel (up to 4). Dimension (L x W x H). Discharge:5°F122°F / -15°C50°C; Charge:5°F104°F / -15°C40°C. 109.8 inch·lb / 12.4 N·m. Super safe lithium iron phosophate (LiFePO4) chemistry. Reducing the risk of explosion or combustion due to high. Impact, over-charging or short circuit situation.·Battery Management System (BMS) controls the. Parameters of the battery to provide optimum safety by. Protecting against over-charging and over-discharging.
·BMS enhanced design balances the battery cells. ·Delivers twice the power of lead acid batteries, even. At high discharge rates, while maintaining high energy. ·Faster charging and lower self-discharge.
·Up to 10 times more cycles than lead acid batteries. ·Compact and only 40% of the weight of comparable lead. ·Rugged impact resistant ABS case and cover flame retardant to UL94:V0. ·ISO9001:2015 - Quality management systems. The PSL-BTC Series come with an intelligent battery.
Management system which monitors current and voltages. This protects the battery from. The BMS embeds smart balancing algorithms that control all. Cell voltages in the battery, making sure they are constantly at.
The same voltage level, optimizing battery capacity. Tests should be conducted with batteries that have less than 5 cycles before the test.
Battery should be discharged at a constant current of 0.33C to 9.2V at 20 ±5 C, then rest for 60 minutes before charging. The batteries should be stored open circuit, and protected against the possibility of a short between the terminals. The battery should be charged once every 6. Months if not in use to prevent over-discharging. They batteries should be stored at room temperature, and charged to 30-50% SOC. If the battery is over-charged and over-discharged too frequently, this will affect the long-term performance and capacity of the battery. If the battery is stored for. Too long, reduced capacity and performance can be expected. It is important to cycle the battery at least once every 6 months and stored at the appropriate SOC to. Prevent deteriation to the battery. Do not short circuit battery. If the battery is short-circuited, it causes excessive heat which will damage the battery and possibly it's surroundings. Do not drop, throw, or crush battery. Do not throw the battery into water or fire. Keep battery away from heat sources, high voltage, and other high-temperature sources. Do not leave the battery exposed to sunlight for extended periods of time. Do not attempt to disassemble the battery.Batteries in strings must always be matched by chemistry, capacity, voltage, and SOC. Do not connect in reverse polarity.
Use matched or suggested charger for this battery. Keep the battery away from high-temperature environments. This can cause over-heating, fire, reduction in battery life, and/or loss of other battery functions. When battery runs out of power, charge your battery in a timely manner (15 days or less).This will prevent premature aging of the battery. Stop using the battery immediately if it emits a burning smell, too much heat, or appears distorted. Severe damage to the battery, short circuiting and sparking will happen if the batteries are not connected correctly or properly maintained. Assembly be completed by fully trained professionals only.
Do not reverse connect the anode and cathode, as this will damage the batteries and/or any equipment connected. DO NOT connect the batteries in parallel AND series at the same time.
Ex: TC12100 has a capacity of 100Ah, so the wire must be able to withstand 200A. Charge all batteries with 14.6V per standard charge. Ensure all batteries have the same voltage level by fully charging each battery prior to connecting in parallel. Make sure the connections are tight and the connector is protected from corrosion, wear, and seimic situations.
DO NOT connect more than 4 batteries per circuit. Make sure capacity stays within 50-60% when storing the batteries. The temperature should be 0-35o. C, humidity 75-85% and fully charged every 3 months and. Once a year, the batteries should be removed from string and individually charged.
The voltage difference upon reassembly should be no more than 0.2V. If connecting with inductive loads e. Microwave, coffee machine, k7 karcher power washer, Compressor, Water Pump, Saw, Drill, old CRT TV, Refrigerator, Ice conditioner, Air conditioner, Relays, Fluorescent lamp, Vacuum cleaner, smoke machine, random orbit sander, orbital polisher, please choose inverter whose rate power is 3-7 times higher than the load's rate power.
For example, for a 150w refrigerator(10 times), please choose a 1500w Pure Sine Wave inverter or higher; for a 800w air conditioner, please choose 2500w Pure Sine Wave inverter or higher. We work hard to ensure that every customer is 100% satisfied.Any questions will be replied within 24 hours except the weekend and statuary holiday in Chinese Beijing Time. This item is in the category "Consumer Electronics\Multipurpose Batteries & Power\Rechargeable Batteries". The seller is "powerform22" and is located in this country: US.
This item can be shipped to United States.